Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
linux_wiki:firewall_firewall-cmd [2016/02/07 18:20] billdozor [Firewalld Components] |
linux_wiki:firewall_firewall-cmd [2016/02/07 18:24] billdozor [Interfaces] |
||
---|---|---|---|
Line 38: | Line 38: | ||
* firewall-cmd method< | * firewall-cmd method< | ||
* systemctl methods | * systemctl methods | ||
- | * status< | + | * check status< |
- | * active< | + | * is active?<code bash> |
- | * enabled< | + | * is enabled?<code bash> |
---- | ---- | ||
Line 88: | Line 88: | ||
firewall-cmd --change-interface=eth0 --zone=home | firewall-cmd --change-interface=eth0 --zone=home | ||
</ | </ | ||
+ | * If you are changing an interfaces zone, chances are, you might also want to change the default zone displayed. See the Zones section above to do this. | ||
---- | ---- |