linux_wiki:firewall_firewall-cmd

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
linux_wiki:firewall_firewall-cmd [2015/12/18 15:52]
billdozor [Firewall-Cmd] 		linux_wiki:firewall_firewall-cmd [2016/02/07 18:24]
billdozor [Interfaces]
Line 14: Line 14:
   * firewall-config => GUI Frontend for firewalld   * firewall-config => GUI Frontend for firewalld
   * firewall-cmd => Cmd line frontend for firewalld   * firewall-cmd => Cmd line frontend for firewalld
-  * firewalld => Daemon that interacts with the Linux kernel+  * firewalld => Daemon that interacts with the Linux kernel's packet filter, Netfilter
     * cannot be used at the same time as iptables     * cannot be used at the same time as iptables
   * iptables => Interacts with the Linux kernel's packet filter, Netfilter   * iptables => Interacts with the Linux kernel's packet filter, Netfilter
Line 38: Line 38:
   * firewall-cmd method<code bash>firewall-cmd --state</code>   * firewall-cmd method<code bash>firewall-cmd --state</code>
   * systemctl methods   * systemctl methods
-    * status<code bash>systemctl status firewalld</code> +    * check status<code bash>systemctl status firewalld</code> 
-    * active<code bash>systemctl is-active firewalld</code> +    * is active?<code bash>systemctl is-active firewalld</code> 
-    * enabled<code bash>systemctl is-enabled firewalld</code>+    * is enabled?<code bash>systemctl is-enabled firewalld</code>
  
 ---- ----
Line 88: Line 88:
 firewall-cmd --change-interface=eth0 --zone=home firewall-cmd --change-interface=eth0 --zone=home
 </code> </code>
 +  * If you are changing an interfaces zone, chances are, you might also want to change the default zone displayed. See the Zones section above to do this.
  
 ---- ----
  • linux_wiki/firewall_firewall-cmd.txt
  • Last modified: 2019/05/25 23:50
  • (external edit)